Installing an Automatic Door in Tehran/IRAN

Installing an Automatic Door in Tehran/IRAN

Nowadays, the automatic glass door in Tehran has been widely welcomed due to its convenience, beauty, and advanced technology. For this reason, beginners and novices should not be consulted for its preparation and installation. Because installing an automatic door is a very specialized job that should be done by experienced people who have completed special courses in this field.

In order to install and adjust the automatic glass door in Tehran, one should be fully familiar with the operation and service of automatic door parts. Because if a person is not familiar with the components and how it works, it may cause the door to fail and not work properly. To avoid such a problem, the best way is to entrust the installation of your automatic door to the hands of our experienced experts in Tehran. Do not worry. As you know, there are different types of automatic doors in Tehran, each of which is installed according to its own method. Familiarity to be able to install them correctly.

Automatic door parts in Tehran/Iran

In general, the parts and components of automatic doors in Tehran are divided into two categories, which are referred to. Electronic parts: electric parts of automatic doors include transformer, board, power, remote, sensor, optical, key, etc. Mechanical parts: Automatic door mechanical parts include rotor, jack, shaft, Teflon gear motor, spool remover and many other parts.

The steps of installing an automatic door in Tehran are generally as follows: At the beginning of the work, the installer must prepare the groove above the door, that is, he must first cut the groove and drill the holes for the screws. Then, after drilling the holes, the installer should mount the upper groove of the door on the ceiling. In the next step, he should leave the lower groove in place, in which case he should remove it and place it under the upper groove of the door. In the fourth step, for installation in Tehran, he should insert the sliding glass door and move the lower groove of the door. align vertically. In the last step, the glass door should be placed on the groove, leveled and leveled using a wrench and up and down, then punching the bottom holes.