Setting Up an Automatic Glass Door

Setting Up an Automatic Glass Door

Steps to set up an automatic glass door

In order to set up an automatic glass door and choose the right model, it is better for experienced experts to go to the desired location and closely inspect the project implementation site. This review is the first step in setting up an automatic door. The second case is to check the amount of traffic and the importance of safety and strength of the automatic glass door. Since automatic doors are composed of important components such as motor, electric lock, battery, power supply and control center, the selection appropriate to the location of the project will be very important.

Setting up an automatic glass door in IRAN/Tehran

1. To start the automatic glass door, first prepare the upper slot. Cut it until you reach the end dimension and then drill the holes.

2. In the next step of setting up the automatic glass door, after drilling the holes, install the upper groove on the roof.

3. At this stage of setting up the automatic glass door, it is time to put the lower groove. Cut it to reach its final dimension. Install the lower groove so that it is almost under the upper groove. Note that at this stage of installing the automatic glass door, do not connect the lower groove to the ground.

4. At this stage of setting up the automatic glass door, enter the sliding door. Raise the door vertically by moving the bottom groove. An important question that you should always ask yourself before setting up an automatic glass door is: